Cup Holder Post V1

implemented unverified

SCREWLESS cup holder for a square wooden post: a LOW ring-wall cup (just enough rim to keep a mug standing; spills drain through the raised floor) with a snap C-clip welded to its outer wall. Push the holder onto the post from the front — the flexing side walls ride over the far corners and the chamfered lips snap shut; the cup's own weight presses the post into the flat seat, so nothing else is needed. 2x2 cm post by default, any 12-30 mm square by parameter.

Built from a real example — orbit to inspect.

Declaration example

A minimal product declaration for this archetype — exposed parameters at their defaults. Validate and build it with forge validate / forge build.

schema: product/v1
id: my_cup_holder_post
archetype: cup_holder_post_v1@1

params:
  cup_d: 92mm
  cup_h: 38mm
  post_w: 20mm

Parameters

parameter	type	default	range	role
`cup_d`inner rim sized to drop a mug in (92 fits most mugs)	`length`	`92mm`	`60mm … 130mm`	functional	exposed
`bottom_d`	`length`	`80mm`	`50mm … 120mm`	functional
`cup_h`LOW ring wall — holds the cup, never hides it	`length`	`38mm`	`26mm … 80mm`	functional	exposed
`wall`	`length`	`2.4mm`	`1.8mm … 4mm`	structural
`floor_t`	`length`	`3mm`	`2mm … 5mm`	structural
`floor_raise`	`length`	`4mm`	`2mm … 10mm`	functional
`drain_count`	`count`	`3`	`1 … 6`	functional
`drain_d`	`length`	`6mm`	`4mm … 10mm`	functional
`post_w`the square post's measured side (20 = the 2x2 cm standard)	`length`	`20mm`	`12mm … 24mm`	assembly	exposed
`fit_clearance`	`length`	`0.5mm`	`0.3mm … 0.9mm`	manufacturing
`clip_h`snap clip height (>= 1.5x post — anti-rock)	`length`	`36mm`	`18mm … 60mm`	assembly
`clip_z`	`length`	`1mm`	`0mm … 30mm`	assembly
`snap_bite`	`length`	`1.2mm`	`0.8mm … 2mm`	assembly
`clip_wall`	`length`	`2.8mm`	`2.4mm … 3.6mm`	structural